Part Number:OMAPL138B-EP
Tool/software: Starterware
Hello!
I'am using StarterWare and trying to use EDMA3_1_CC0 channel controller to read/write flash through SPI0 interface.
Everything works fine with EDMA3_0_CC0.
With EDMA3_1 no EDMA interrupts occured...
Trying to debug situation...
after SPIIntEnable(...) rises corresponding bit in ER (event register), but in EDMACC0DSP register group (view registers in debug window).
As i understand this bit should be in EDMACC1DSP group, because i used SOC_EDMA31CC_0_REGS only. So no EDMA3 interrupt occured.
Can anybody help?