Hello,
I have several doubts regarding the Serial Flash and Boot utils. My questions are the following:
I'm using the OMAP-L137_FlashAndBootUtils_2_40 version.
1) How do I know if I need to rebuild the host and target side applications?
2) What do I need to modify in the case of a custom board (my case)?
3) How can I build them? I followed the instructions in the wiki and the ones explaind by Shankari at https://e2e.ti.com/support/dsp/omap_applications_processors/f/42/p/464743/1676838, however I haven't been able to build them. I have tried several times and no result.
4) For the AM1705 can I use any of these applicacitions OMAP-L137_FlashAndBootUtils_2_40 and OMAP-L138_FlashAndBootUtils_2_40? They are mentioned in the forum as they are equivalent and is very confusing.
I will really appreciate your advice, I'm stuck. Please help.
Best regards,
Patricio Cohen