Hi OMAP-L137 Team,
The TMDSOSKL137 board UART doesn't work if baud rate is programmed to over 115200. Is this caused by the L137 controller or the board design?
I have modified the pspdrivers_01_20_00.packages.ti.pspiom.uart to let the uart controller be able to set baud rate to 230400 on TMDSOSKL137. But this baud rate doesn't work. My project needs OMAP-L137 UARTs run at 3 Mbps of the maximum speed mentioned on the OMAP-L137 data sheet. Can my new design achieve this official speed mentioned on the data sheet? Please be noted that my UART transceiver does support over 230400 baud rate.
Regards,
Ping Tai