Part Number: LINUXSDK-OMAPL138
During the development one of our device using the OMAP-l138 has stopped working. The device is not turning on after powering it ON. Also observed that the device is not entering the bootloader prompt. So, in order to recover the device we wanted to the flash the bootloader image over uart2 on SPI MEM. But we are seeing the issues mentioned below. Please do the needful.
We are seeing issues with the board using omapl138. When we are flashing the bootloader binary on SPI FLASH over UART2 using the utility sfh_OMAP-L138.exe. During the SPI mem flashing using uart2 it is stuck at Waiting for SFT on the OMAP-L138... .
Attempting to connect to device COM1...
Press any key to end this program at any time.
(AIS Parse): Read magic word 0x41504954.
(AIS Parse): Waiting for BOOTME... (power on or reset target now)
(AIS Parse): BOOTME received!
(AIS Parse): Performing Start-Word Sync...
(AIS Parse): Performing Ping Opcode Sync...
(AIS Parse): Processing command 0: 0x58535901.
(AIS Parse): Performing Opcode Sync...
(AIS Parse): Loading section...
(AIS Parse): Loaded 9200-Byte section to address 0x80000000.
(AIS Parse): Processing command 1: 0x58535901.
(AIS Parse): Performing Opcode Sync...
(AIS Parse): Loading section...
(AIS Parse): Loaded 740-Byte section to address 0x800023F0.
(AIS Parse): Processing command 2: 0x58535906.
(AIS Parse): Performing Opcode Sync...
(AIS Parse): Performing jump and close...
(AIS Parse): AIS complete. Jump to address 0x80000000.
(AIS Parse): Waiting for DONE...
(AIS Parse): Boot completed successfully.
Waiting for SFT on the OMAP-L138...