can I get any sample code on TMDXLCDK 138 omap l138 kit, I have bought the kit from the estores of texas and I am not knowing how to do coding on the kit and after installing ccs can we have to add libraries for omap l138 lcdk,,i want to interface ultrasonic sensor to the kit,, how can i do this, i am new to the DSP kit, and i am not getting any sample code to run in the kit. i am trying to run the sample code given in the ti resource explorer but when i am debugging the imported project then error
(C674X_0: GEL: Encountered a problem loading file: C:\TI_RTOS\Workspace\bigtime_LCDKOMAPL138_TMS320C67XX\Debug\bigtime_LCDKOMAPL138_TMS320C67XX.out Could not open file ) and (
ARM9_0: Output: Target Connected.
ARM9_0: Output: ---------------------------------------------
ARM9_0: Output: Memory Map Cleared.
ARM9_0: Output: ---------------------------------------------
ARM9_0: Output: Memory Map Setup Complete.
ARM9_0: Output: ---------------------------------------------
ARM9_0: Output: PSC Enable Complete.
ARM9_0: Output: ---------------------------------------------
ARM9_0: GEL: Error while executing OnTargetConnect(): Target failed to write 0x01C11100 at (*((unsigned int *) (0x01C11000+0x100))&=~(0x00000001)) [OMAP-L138_LCDK.gel:4] at device_PLL0(0, 24, 1, 0, 1, 11, 5) [OMAP-L138_LCDK.gel:403] at Set_Core_300MHz() [OMAP-L138_LCDK.gel:468] at Core_300MHz_mDDR_150MHz() [OMAP-L138_LCDK.gel:245] at OnTargetConnect() .
ARM9_0: Error: (Error -1060 @ 0x2E18) Device is not responding to the request. Reset the device, and retry the operation. If error persists, confirm configuration, power-cycle the board, and/or try more reliable JTAG settings (e.g. lower TCLK). (Emulation package 5.1.232.0)
ARM9_0: Unable to determine target status after 20 attempts
ARM9_0: Failed to remove the debug state from the target before disconnecting. There may still be breakpoint op-codes embedded in program memory. It is recommended that you reset the emulator before you connect and reload your program before you continue debugging
Texas Instruments XDS100v2 USB Emulator/ARM9_0 : Target must be connected before loading program.) is coming
and it is coming to select the platform but there is no platform for lcdk omapl138 in the drop down menu i am attaching the image,, i have ti xds 100v2 emulator and i want to do coding through ccs
when I am using sample code for omal l138 lcdk in RTSC configuration setting I am not getting platform for OMApL138 LCDK, there is only platform for EVM Modules ,, what i have to do,, I am attaching the image
Please help i am not getting any solution