Hai,
We were using Sitara AM1810 processor, for this we interfaced DDR2 of 128MB.
When we power the board we were seeing "BOOTME" message on the console
Then we compiled the u-boot for AM1810 with the below configuration
make da850evm_config
make
it generated the u-boot.elf & u-boot.bin
Using AIS.gen tool we generated u-boot-ais.bin file using u-boot.elf, when we load u-boot-ais.bin file through UART Host, we were not seeing any messages on console.
We tried by changing DDR2 timing parameters still there are no messages on console
Then we added some led on/off logic at start-up, but still there is no change.
Kindly let me know your inputs.
Thanks,
Srinivas