RTOS/OMAP-L138: Problem in SPI communication.

Part Number:OMAP-L138

Tool/software:TI-RTOS

Hello,

I am using OMAP-L138 LCDK for Analog processing (with ADC LTC1856) for my university project. With SYS/BIOS 6.46.5.55 I am trying to configure SPI.

I am referring code from TI support, 

                      OMAPL138_StarterWare_1_10_04_01 - example code for SPI

I could build the project on board where I am using SPI1 (default) and transmitting signal at 3 pin mode.

I am not getting any received data at pin SPI_SIMO.

And also at pin SPI1_CLK my oscilloscope is not showing any clock.

In short, my SPI is not working. 

Could you please help, how to proceed further in troubleshooting. 

Regards,

Kshitika

University of strathclyde, Glasgow