Part Number:OMAP-L137
Dear friends,
I am working on 'evm omap l137' and I have problem in booting the DSP code.
Currently I am able to run DSP code using ccs5 and xds510 debugger. But I am not able to boot this code.
I have followed these steps
- .out file is converted to .bin using AISgentool, selected ROM ID as d800k001 and selected configure for evm option.
- .bin file is loaded in flash using SPI programmer application with option as 'dspais' (which loads the .bin file at 0 location of flash.)
Then after reset I was expecting code to boot and work, but it is not happening.
I have followed same procedure for 6745 dsp based board (with rom id:d800k005) and it is working.
Is there any additional step for omapl137 when compared 6745.
I don't need arm so i have not loaded any arm code.
kindly help me.
regrads
Jagdish