Hi,
I just bought a OMAP L138 and a XDS100v3 JTAG emulator for a school project, but when I set up the target in code composer I always get the following error when testing the connection. My LCDK is plugged in to the 5V cable and the XDS100 to the miniusb port.
An error occurred while hard opening the controller.
-----[An error has occurred and this utility has aborted]--------------------
This error is generated by TI's USCIF driver or utilities.
The value is '-180' (0xffffff4c).
The title is 'SC_ERR_CTL_NO_TRG_POWER'.
The explanation is:
The controller has detected a target power loss.
The user must turn-on or connect the power supply for the target.
[End: Texas Instruments XDS100v3 USB Debug Probe_0]
Any help will be appreciated.
Thanks
Mauricio