AM1705 GEL Script Error when Powering EMIFA

Hi there,

I'm having issues powering up the EMIFA peripheral through the GEL Script for an AM1705. I've attached my current GEL Script with the PSC0_lPSC_enable(0,3) uncommented out. When it is run like this I get the following output:

(Please visit the site to view this file)

However when I run it with that line commented out I get this:

(Please visit the site to view this file)

Occasionally when I run it without initialising the PLL then the error says that "the controller detected a target power loss". 

During the PLL initiasation I've probed the 1.2V pin for the PLL supply and that holds steady without any drop in voltage.

I've also documented another issue that I had with the GEL Script here: 

Let me know if you need any more information or tests that I should do.