CCS 6.1.1
XDS100v2 JTAG
Starterware NandWriter (ARM) firmware
OMAP-L138-EP
All:
I am seeing peculiar behavior on some target boards. When I try to program the Nand using CCS 6.1.1 and a desktop computer, the program gets only to thru the first line on the display (Stating NANDwriter...)
If I then switch the JTAG to a laptop computer, I am able to get to the second and following lines...
"Do you want to do a global erase of the flash?"
The JTAG is the same, I am using CCS 6.1.1 on both desktop and laptop.
Even more bizarre is once I am done programming the flash on the target, I can go back to the desktop computer for subsequent loads of code onto flash.
Is there any explanation that can be given?
Has anyone else seen behavior like this?