TDA2EG-17: How to add DS90UB964 driver in PDK

Part Number: TDA2EG-17

Hi all

I want to use TDA2EX17 board +  DS90UB964-Q1EVMTDA  + 4 * mipi camera modules (ti933 + ov9716)   to capture four camera image to display on HDMI or LCD. 

After I read pdk_datasheet.pdf, ISS Capture Driver (CAL) support  TDA3X and TDA2PX, If  I want to use DS90UB964 on TDA2EX17,  to add the  driver like bspdrv_ov490Api.c in pdk??, then, usercase can use the driver ID and driver instance id  to operate the hardware by the driver(like FVID2_VID_SENSOR_OV490_DRV), because, it does not have any driver about ub964 in pdk. 

ISS Capture Driver (CAL)
ISS captures video streams via CAL sub-block of the ISS. It provides interfaces to capture via mipi CSI2 and Parallel. Typically used to capture streams from sensors such as Omnivision 10640, Aptina Ar0132 & Aptina
AR0140. To measure the performance, RAW 12 video stream @ 30 FPS is captured from OV10640 and written into memory.
Setup Details
• TDA3xx/TDA2Px EVM
• Sensor - Omnivision OV10640, Data Format as RAW 12

Best wishes.

Thanks,