Hi,
I'm trying to trigger AD-conversion by the external pin of an timer. I have in general 2 questions about the timer output pin TM64P3_OUT12:
1.) Is there any difference between the pin TM64P3_OUT12 and TM64P2_OUT12? Are Both pins having the same signal and are related to timer12?
2.) Is my calculation of the pulsewidth of the outputsignal on the TM64P3_OUT12 pin correct? My systemclock is 456MHz and when i set PIWD=4, is the pulsewidth 10.9 ns? This sounds a little bit short for me for an external signal.... The ADC that i will use can handle a minimum pulsewidth of 15 ns..
Note: I got the calculation out of SPRUFM5d.pdf page 23.
Thanks a lot for helping me to understand!
BR,
Christian