Hello,
Does following description in the datasheet also correspond to revision "D"? H4 and F3 pin are connected to ground through filter circuits on custom board. For more robust ESD, should these pin are connected to ground directly or not connected?
Important Notice: On the original device pinout (marked "A" in the lower right corner of the package), pins USB0_VSSA33 (H4) and USB0_VSSA (F3) were connected to ground outside the package. For more robust ESD performance, the USB0 ground references are now connected inside the package on packages marked "B" and the package pins are unconnected. This change will require that any external filter circuits previously referenced to ground at these pins will need to reference the board ground instead.
Regards,
Kazu
